Concrete Curing Compound

Approx. Rs 150 / LitreGet Latest Price

Dr. S. Bond Concrete Curing Compound is a white, low viscosity wax emulsion which incorporates a special alkali reactive emulsion breaking system. This system ensures that the emulsion breaks down to form a non penetrating continuous film immediately upon contact with a cementitious surface. This impervious film prevents excessive water evaporation which in turn permits more efficient cement hydration, thus reducing shrinkage and increasing durability. Once formed, the membrane will remain on the concrete surface until eventually broken down and eroded by natural weathering. Where it is required to apply a further treatment to such concrete surface, it may be necessary to remove the membrane remaining after curing by wire brushing or other mechanical means. A curing compound based on aluminized synthetic resin for the prevention of premature water loss from concrete. It is in ready to use form and simple to apply.

Advantages:

Dr. S. Bond Curing Compound provides the following beneficial properties to concrete surfaces:

• Reduces incidence plastic cracking.
• Ensures achievement of desired strength.
• Minimizes shrinkage.
• Reduces dusting.
• Increases frost resistance.
• Alleviates other costly methods such as hessian-watering, etc.
• Single application: Forms moisture barrier for whole of the curing period.
• No other curing necessary: Eliminates use of water, hessian or sand completely.
• Reliable: No risk of erratic or poor curing and ensures that cement hydrates efficiently.
• Ensures hard-wearing surface: Minimises risk of drying, shrinkage, cracks and dusty surfaces.
• Easy and safe spray application: Non-toxic and non flammable.

• Highways
• Runways and taxiways
• Aprons and hard standings
• Roof decks
• Retaining walls

• Exposed Concrete Slabs - Dr. S. Bond Curing Compound should be spray applied on to the newly placed concrete slab as soon as possible after it is free from visible surface water, e.g. typically 1 to 2 hours after placing.
• Shuttered And Precast Concrete - Dr.S.Bond Curing Compound curing agent should be spray applied to all surfaces as soon as formwork has been removed or the element remolded. In all cases the nozzle of the spray should be held approximately 450mm from the concrete surface and should be passed back and forth to ensure complete and even coverage. The pump pressure should be maintained at a level to produce a fine spray ensuring complete coverage of the surface. Rate of application depends on requirements but is typically within the range of 200 to 285 ml / m2

• Dr. S. Bond Curing Compound has a shelf life of 6 months when stored at temperatures between 5⁰C and 35⁰C. Containers should be kept airtight to prevent surface evaporation. Freezing or prolonged exposure to direct heat or sunlight must be avoided.
• Equipment cleaning - Immediately after use the spray equipment should be cleaned out thoroughly with fresh water. If the spray nozzle becomes blocked with wax particles these can easily be removed using white spirit or similar fluid.
• Fire - Dr. S. Bond Curing Compound is water based and non flammable.

Additional Information:

Approx. Rs 150 / LitreGet Latest Price

Approx. Rs 150 / LitreGet Latest Price

Approx. Rs 150 / LitreGet Latest Price